Page 1 of 1

Best beef cut for hamburger

PostPosted: Sat Jan 05, 2008 10:55 pm
by grannyk
Now that I have a meat grinder, I want to make my own ground beef for hamburgers. What cut of beef would be the most flavorful (without being TOO high in fat). When I buy ground beef, I usually buy the 7% fat - but it seems to lack in flavor.

PostPosted: Sun Jan 06, 2008 4:14 am
by TJ Buffalo
It depends on what 'too fatty' is to you. I grab some reasonable-looking chuck (about 18 - 20% fat) when I grind my own hamburger.

PostPosted: Sun Jan 06, 2008 5:09 am
by Iamarealbigdog
I could write all day about ground beef, if you want lean go for eye of the round, best flavour is in the sirloin, (tip is more cost effective). a hard worked muscle is tough but more flavourful

PostPosted: Sun Jan 06, 2008 8:27 pm
by grannyk
Thanks for the tips. I asked the butcher yesterday what he recommends and he said he likes the chuck. So I bought some and will try it tonight. It does have a higher fat content that but I supposed I can trim some away. It will interesting. Nothing like a good hamburger!

I'm also going to make up my first batch of breakfast sausage today. I hope it turns out OK.

PostPosted: Mon Jan 07, 2008 12:36 am
by Ianinfrance
Personally I think the best flavoured beef comes from the shin. When you're mincing it, the fact that it's a bit tough doesn't matter neither does the proportion of connective tissue. What's more, shin is one of the leanest cuts too.

All these prime cuts!!! What a waste. I use those for grilling or roasting.

PostPosted: Mon Jan 07, 2008 5:54 am
by grannyk
Well, I ground up the chuck today and made hamburgers tonight. I have to say the texture was wonderful and the flavor was ok. Next time, I am going to try Alton Brown's recipe and mix sirloin and chuck together. Plus, I may not have added enough salt.

I also made up my first batch of breakfast sausage today. Overall, I think the grinder attachment for the Kitchen Aid works well. When I first starting grinding the beef, I didn't have the grinder tightened and it started spinning around. I had a bit of a mess to clean up by the time I could get the mixer turned off. I hopefully won't make that mistake again.

Thanks again for your tips.

PostPosted: Wed Jan 16, 2008 4:28 am
by Bad Flynch
If you want to up the flavor some, increase the fat content. Chuck, as it is sold today, probably runs 20-21% fat. If you will add fat to get to 25% or just a little over, it will help.

Most hamburger in the U.S. sold these days is far too lean for a good, juicy burger.

PostPosted: Wed Jan 16, 2008 1:13 pm
by akesingland
Hi All

In Hestons perfection http://www.bbc.co.uk/food/recipes/datab ... 7366.shtml he uses chuck, brisket, and short rib meat (1:1:2). I did make just the burgers but replaced the short rib with rump (I just could not source it). Two people said it was the best burger they had ever tasted.

Cheers
Adam