Page 1 of 1

Elitech DHC-100 problems

PostPosted: Sat Jan 20, 2018 5:21 pm
by Sam3
Good evening, I hope everyone is keeping well.

As a newbie here and someone who is just in final stages of building / converting fridge into a curing chamber, I have now came across a technical issue with above controllers

Hence I Need some help from you intelligent and experienced ladies and gentlemen.

I have today finally received my second elitech Humidity controller, for to install into curing chamber control panel.

One for humidifier and one to control dehumidifier.

However my problem is the two sensors are both giving completely different readings

Have read in the instructions about calibration, and changed one sensors Data to the same as the other sensor thinking this would make them read the same, alas no avail, so I am guessing that both sensors need calibrated, but haven’t a clue how to.

Do any of you know how to do this and what the “zero offset” and “slope” figures mean / represent

Re: Elitech DHC-100 problems

PostPosted: Sat Jan 20, 2018 6:37 pm
by wheels
Are they both in the same area of the chamber?