by aeddon » Wed Nov 30, 2005 4:46 pm
and the reply...
START
From: Paul Kribs
To: aeddon
Posted: Wed Nov 30, 2005 4:33 pm
Subject: Re: lomo stage 2 help....
aeddon
don't panic at all. It is all quite a forgiving process once you have initially cured it. If your hooks are stainless steel then fine, if they are not take them out as there could be a reaction between the cure and the steel. There is a way around this using butchers twine, by making a slip knot and placing it around the top of the Lomo about 1/2" down from the top and then hanging the Lomo via the twine to a hook.
With regard to the lard, you are correct in that it becomes more malliable as you work it in your warm hands. You do not need to smear loads of it on, just a bare covering. Then lightly sprinkle the paprika (sweet or smoked) onto the lard and work it in for a few minutes. Then let it hang and mature. Once the maturation time is finished, gently wash the Lomo with warm water to remove the lard/paprika covering. Pat it dry with kitchen paper or a teacloth and allow it to hang for a few hours to dry the outside. You have succeeeded in the hard part and all you need now is the time... then enjoy. To carve, use as thin a blade as possible and although it may be long winded, wipe the blade between each cut with a damp cloth to remove the build up of protein which will, if left on, tend to stick and tear the Lomo.
As I say, enjoy your Lomo.. I must do another soon.
This may have actually been beneficial to be posted on the main forum to assist others in the future.. no worries though. Good luck.
Regards, Paul Kribs
END
thankyou paul