Not sure if this is what you are looking for, have changed the weights down as I do this in a 30Kg batch. It might look simple [well it is
] but it has a great taste.
Garlic Rings
7.500 Kg
Meat Block:
2 Kg Lean cubed pork salted with 20gm per Kg of curing salt for twenty four hours.
.750 Kg Beef with a small amount of fat left on
2.500 Kg Boneless picnic
2.250 Kg Jowl
Spice Block:
20 gm Curing salt for all the unsalted meat (5.500 Kg)
Spices for total meat block (7.500 Kg)
2 gm sugar
3 gm White pepper
¾ gm Nutmeg
½ gm Ginger
2 gm Fresh garlic cloves put into the cutter with the meat
Place beef into cutter along with the salt
Make the emulsion with ice
Add the jowl when emulsion is three quarters done
Stop cutter and clean out the lid, close and start cutter on slow speed add spices when blended in stop cutter and clean lid again
Add lean meat and close lid, start cutter on slow speed and blend like course meat loaf
Place in stuffer excluding as much air as possible, fill into 42/45 hog casings prepared to form a 500 gm ring
Instead of filling into the 42/45 hog casings fill into 120mm waterproof casings and cook in hot water like you do your Mortadella
I will leave the rest intake in case anyone would like it.
Place on the hot smoke truck and let dry to tacky before smoking
Pre heat the smoke generator
Place in the temperature probe into the sausage before closing the door
Turn on the humidity
Start smoking at 135 degrees for thirty minutes then turn on the smoke generator re-setting the timer for thirty minutes when the temperature is increased to 145 degrees for the second hour after which the temperature is raised to 165 degrees for the last hour.
When timer hits two hours and forty five minutes turn off the smoke this helps for not having a face full of smoke when opening the door at the end
When fully cooked turn off the smoker and take out the sausage and place in cold water to stop cooking and also cool down, when cool take out of water and rinse with hot water and re-hang on smoke truck to dry off (1/2 hour) then transfer to cutting room.